View Cart  Contact Us

INSTALLING A McGREGOR POOL SAFETY FENCE - 5

Cement Footings for Deer Fencing

 

INSTALLING CEMENT FOOTINGS

Some pool fence posts should be put in cement footings, these generally being gate posts and posts to which earth anchors are attached. You do not need to put your corner posts in cement footings if these posts are not braced.

 

How To Install Cement Footings for Deer Fences

Note that if your fence never needs to deal with heavy, wet snow at a time when the ground is unfrozen, that relieves its ground-gripping parts of an immense potential weight burden.  So if you are putting up a short pool fence in Georgia or California, you may reasonably decide to forego the joy of installing cement footings.

To create a cement footing, start by digging a 10 to 12-inch diameter hole with an auger or manual post-hole digger. This hole should be below the frost line if there is deep winter ground frost, and 2 feet deep if frost is not a problem. If the hole is, say, 3 feet deep, fill the bottom 12 inches with large rocks (softball to hardball size), place the post in the hole, and measure to ensure that the top is 7 feet above the ground, adding or removing rocks as necessary to obtain the proper height. If the hole is 2 feet deep follow the same procedure without initially placing rocks but adding rocks if necessary.

 

Post being driven down

Cement Footings for Deer Fence Posts

Plan on using a high-strength concrete mix (cement mixed with crushed rock) that should be available locally in 60 or 80 pound bags. Do not use the quick-setting type unless that is the only kind available. Mix cement and water to create a batch of cement with a jelly-like consistency. Use this soupy mixture to fill the hole to a few inches above the rocks if the hole is over 2 feet deep, or to a depth of a few inches if the hole is 2 feet deep.

Cement Footings for Deer Fencing

Then place the post in the hole and use moderate-size rocks to secure it firmly in place until it can stand on its own, keeping the post as close as possible to the center of the hole. Take a carpenter’s level and place it against the side of the post to make sure the post is straight up and down; adjust as necessary until the post is vertical. Also measure to make absolutely sure (especially if you are using a top rial and/or welded wire fencing) that the post will be tall enough so that the fencing (when hung from the top rail or brace band attached to this post) will barely touch the ground. Then fill the hole to the top with the cement mixture and take another level measure to ensure that the post has not shifted. Let the cement set for 12-24 hours if the temperature is above 60º F, or for 24-48 hours if the temperature is below 60º F (it is not advisable to do this work if the temperature is below freezing).

 

Continue
Back to top
Back to pool fence introduction

 

 

Responsive Ecommerce Design by Thrise